![]() Update.bin is hekate and it is already copied with the bootloader folder drag n drop update process. In any case, bootloader/update.bin, will be checked and if newer it will get loaded. You can choose to update your RCM injection device or PC with the new hekate_ctcaer_x.x.x.bin or not.No need to delete that folder first, especially if you want your configs and payloads. Drag n drop bootloader folder into sd card root and hit merge/replace.You can also view that file with text editor and see what it does. something that many partitioning tools neglect.įor maximum performance of UMS in Windows, you need to run nyx_usb_max_rate_run_only_once_per_windows_pc.reg, only once per PC you have. That's because it prepares it for performance. It is also suggested to format your sd card via hekate. You can even use it when you have exFAT and you want to format to FAT32. You can still reformat your SD card to a single FAT32 partition. Can the Part manager be used for something else? Which Linux/Android distributions are supported in Partition Manager?įor L4T Linux you can use the official Ubuntu Bionic 3.4.0 and newer or any other distro betas. UTILS: Removed stop rtc alarm from power management functions.INPUT: Reordered power on of touchscreen in order to induce a small reset at start.SDRAM: Added a function that allows latency allowance for SDMMC1 to be patched to eMMC values.SDMMC: Added debug printing functions of all SD card registers (CID/CSD/SCR/SSR).SDDMC: Added sdmmc driver type set support.SDMMC: Fixed an issue with sd removal detection.By spec, it only matters on SDR50 and up. SDMMC: Corrected the order of setting SD power limit.SDMMC: Added proper SD DDR50 bus speed mode.SDMMC: Added SD UHS DDR200 bus speed mode, capable of reaching 200MB/s on UHS-I bus.Ĭan be enabled with the BDK_SDMMC_UHS_DDR200_SUPPORT build time flag.GPIO: Reorder configuration of input/output functions in order to mitigate bad configs from previous loaders.SD Card/eMMC benchmark now stalls less between each read, in order to stress the cards more.Since in that case the Switch was awakened via Power or USB, all flags are now cleared during Auto HOS Power off checks. Fixed an edge case where if hekate was run and the rtc alarm was fired after, booting to HOS would power off the device.L4T: Added a mandatory change for supporting SD UHS DDR200 bus speed for Linux/Android.L4T: Now some 2019 T210B01 Samsung ram chips can be overclocked to 2133 MHz for Linux/Android.A mitigation was added for bad chainloaders that leave sd gpios in a bad state.No more SD card removals Supports: Erista (T210) and Mariko (T210B01) units Latest HOS supported: 16.0.2 hekate v6.0.3 changes Supports booting ALL current CFWs, Android/Linux booting and payload tools.
0 Comments
Leave a Reply. |